top of page
Bannière V4.png

Front Axle Bearing Golf mk6

The tightening torques

Tightening torques

Wheel bearing holding screw: 70 Nm + 90°

Control arm ball joint holding screw: 100 Nm

Driveshaft nut: 200 Nm + 180°

    - Socket wrench
    - Wheel lug wrench
    - Torque wrench
    - 16mm socket
    - Paper towel
    - Hammer
    - Wire brush
    - Correction fluid
    - M24 Triple square socket
    - M12 Triple square socket
    - Sandpaper
    - Breaker bar
    - Slide hammer
    - Brass brush

Needed tools

The complete toolbox recommended UseTool EN

- Brake cleaner

- Penetrating oil

- Front axle bearing

Needed parts

Tips

Disclaimer: This video was created for information purposes and does not guarantee the outcome of actions undertaken.
To ensure that you see the best results, we recommend getting in contact with qualified technicians who will carry out the installation.
This video provides tips and recommendations that can be useful when repairing or changing parts. MCD12 and its partners cannot be held responsible for any physical and material damage that comes from the poor installation or incorrect interpretation of the video content.
This video was created for information purposes and does not guarantee any outcomes. The user is solely responsible for the incorrect use of repair machines, tools and parts, in particular if these may cause physical damage. MCD12 and its partners recommend taking great care and carefully following the safety rules when carrying out the repair or replacement of any parts. Please keep in mind that using poor quality parts compromises the safety of the driver when on the road.

bottom of page